Front spacers Ford C-MAX Energi 2014-н. In to increase клиренса aluminum included 2 PCs-автопроставка buy set

Front spacers Ford C-MAX Energi 2014-н. In to increase клиренса aluminum included 2 PCs-автопроставка buy set

Spacers for front racksFord C-MAX Energi (CCG) 2014-st. timeTo increase clearanceIt isThe most popular way to increase traffic clearance.

Spacers under the springs, racks, shock absorbers are installed both on new cars, and on cars with mileage, thereby increasing the clearance of the car and protecting the lower bodies of the car.

These parts are designed to comply with technical tolerances and requirements, and do not carry negative impacts on the angles of the drives, the tension of the brake hoses, the voltage of the Silens. No improvements are required when installing the exhibitions

The spacers appliedPowder polymer coating-The most effective way to protect parts from the destructive effects of oxides.

The mainThe advantages of spacersIncrease ground clearance:

-Increase of auto passability;

-Reducing the dynamic load on the suspension;

-Improving the appearance of the vehicle;

-No landing during installation of HBO (gas-bath equipment)

-Increase comfort from car control

-Possibility of towing a trailer

Brand name

Auto Spacer (TM)

The purpose of the

Spacers to increase clearance

Installation place

Front axle

Material

Aluminum

Thickness

20mm, 30mm

Quantity in set

2 spacers, elongated fasteners (where necessary)

Installation Instructions

Complete

Country of Origin

Russia

1. remove the rack, make sure that the spacer fits to the support of the cushioning rack and corresponds to the elongated fastener.

2. In most cases, it is necessary to spring the rack to replace the fasteners.

3. replace in the support Cup the regular fastener with an elongated from the kit.

4. assemble shock absorption rack.

5. set the spacer on the support, then the whole structure on the car.

6. after installation of the exhibitions, it is necessary to loosen and restretch the silentblocks of the suspension levers (relieve the voltage) to avoid premature wear of the silent. The broach is made when the car isNot in suspended conditionAnd it stands on wheels, or a stand under the wheel is framed

7. after installation, it is recommended to check "Camber".

Service

* Пpи уcлoвии coxpaнeния тoвapнoгo видa and цeлocтнocти упaкoвки, ça иcключeниeм тoвapoв нaдлeжaщeгo кaчecтвa from пepeчнeй, утвepждeнныx Пocтaнoвлeниями Пpaвитeльcтвa No. 55 from 19.01.1998 and 942 from 10.11.2011 (T. H. Тoвapы личнoй гигиeны and пo уxoду ça peбeнкoм, тpикoтaж, пocудa and дp), and тoвapoв имеющиx индивидуaльнo-oпpеделенные cвoйcтвa.

Инфopмaция o пpoдaвцe