Brand New 40W Laser Power Supply for CO2 Engraving Cutting Engraver Machine 220V/110V | Инструменты

Brand New 40W Laser Power Supply for CO2 Engraving Cutting Engraver Machine 220V/110V | Инструменты

Brand New 40W Laser Power Supply for CO2 Laser Engraving Cutting Engraver Machine 220V/110V

Tip:

This Power Supply  only apply my shop laser engraver machine,If your machine isn't in my shop buy ,please take caution.

The power is adjustable through it's TTL control or by a 5K variable resistor. It support any CO2 laser for up to 40Watt. Small design with excellence PWM control circutry.

1.Input voltage: AC220V or AC110V (to be specified when placing order).

2.Maximum output voltage:DC 25KV.

3.Maximum output current: DC 20mA.

4.Isolation Withstand voltage: Input-output, input-enclosure: AC2000V-10mA-60s; negative pole of output connected to enclosure.

5. Protection: with well-grounded enclosure, output circuit of power supply can be

open for short time (but arc between positive pole and enclosure should be avoided).

6.Response time (from time of input being available to the output current being up to nominal value): <1ms.

7.TTL voltage level control: effective voltage level can be high or low through setting.

8.Protection switch: for detection of cooling water, to protect laser device; or activate with enclosure is opened.

9. Laser power adjustment: (1) by adjusting the output current of power supply through resistor; (2) through PWM control (magnitude being TTL voltage level).

10. Environmental requirements: temperature (-10~ 40 C), relative humidity<85%.