СУПЕР500 СУПЕР 500 500КГ.СМ Мощный металлический сервопривод 12-24В постоянного тока поддерживает PWM BEC 5В для создания крупных роботизированных рук в домашних условиях.

Parameters:   Power input: 12V-24V DC (V-connected negative, V + connected to the cathode) No load current: <500MA Maximum torque: 200KG.CM / 300KG.CM/500KG.CM (24V) (measured, non-theoretical) Angular velocity: 0.5S / 60 ° (60 degrees for 60 degrees), 24V Rotation angle: 300 ° MAX, meaning the maximum stroke of 300 degrees (0 to 300 ° adjustable electronic limit) Input mode: pulse signal (remote control, multi-way servo controller, microcontroller) or analog voltage signal (potentiometer) Pulse signal input range: 1.0ms-2.0ms Analog voltage signal input range: 0V to + 5V   Control and interface description:   Motor output (M +, M -): M - connected to the motor negative, M + connected to the motor positive Motor speed adjustment input (LD): used to control the steering angle of the   Servo   . Corner Adjustment Input (XC): Used to control the angular range of the   Servo   . Mode selection (VR): not short for the pulse signal PWM 1-2MS input, short for the analog voltage signal input 0-5V; default PWM input Servo mode (360): Not short Connext for the normally Servo , short for 360-degree Servo; default Normal Servo  Analog control mode (5V-VR-GND): The angle input signal is analog, you can use the potentiometer to control the motor shaft angle position. Digital control mode (PW-5V-GND): The input signal is a digital square wave signal with a pulse width of 1ms-2ms.     Product Features :   This Servo using the large steering gear in the structure of the steel gear, gear clearance design is reasonable, almost no virtual position, with a brush 540 motor drive, high durability, CNC manufacturing shell, and with a flame retardant ABS shell , a certain degree of waterproof, the installation method of science, and equipped with a steering wheel .   The Servo is driven by a digital circuit that is responsive and has a large stroke and is perfectly compatible with the remote control system on the market. Exclusive power-stable technology to ensure that the steering gear to work, overload will not damage the structure and circuit, once removed part of the steering gear can automatically resume, continue to work. The circuit can be stable control of the steering gear in the safe torque work, never dropped, the steering gear control panel to cancel the traditional potentiometer to detect the location of the shaft method, switch to the original imported magnetic encoder, the use of magnet as a position feedback , Non-contact detection, longer life, will not produce mechanical wear, will not be affected by dust and other effects of normal work. Support PWM pulse 1-2MS signal control that is the standard servo control signal, analog voltage signal control 0-5V, a normal steering gear function, there are 360-degree mode of operation optional, you can control the speed of the steering gear. The servo comes with BEC5V output, can directly to the receiver power supply.   This SUPER500 Servo the last two deceleration is the use of machining gear, durability is better, overload will not cause gear damage.      

 

 

---